Rohde & Schwarz R&S ZNA Series - Page 1655

Command reference
R&S
®
ZNA
1655User Manual 1178.6462.02 ─ 29
TRIGger[:SEQuence]:LTRigger[:STATe] <Boolean>
Activates/deactivates tracking of lost trigger events.
Parameters:
<Boolean> ON (1)
Lost trigger traclking active
OFF (0)
Lost trigger tracking inactive
Manual operation: See "Activate Lost Trigger" on page 880
TRIGger[:SEQuence]:LTRigger:COUNt?
Returns the number of lost trigger events the analyzer firmware observed since the last
reset of the lost trigger event log (see TRIGger[:SEQuence]:LTRigger:RESet
on page 1655).
Usage:
Query only
Manual operation: See "Sequence" on page 561
TRIGger[:SEQuence]:LTRigger:RESet
Clears the lost trigger event log.
Usage:
Event
Manual operation: See "Clear Lost Trigger Log" on page 880
TRIGger<Ch>[:SEQuence]:MULTiple:HOLDoff <MeasSequence>[, <DelayTime>]
Sets a delay time between the trigger event and the start of the measurement ("Trigger
Delay") in multiple trigger mode.
Suffix:
<Ch>
.
Channel number
Parameters:
<MeasSequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence, PPOint denotes "partial
measurement"; see TRIGger<Ch>[:SEQuence]:LINK.
<DelayTime> Delay time
Range: 0 s to 13680 s
Increment: 10 ms
*RST: 0 s
Default unit: s
Example: See TRIGger<Ch>[:SEQuence]:MULTiple:SOURce<inp>
Manual operation: See "... /Logic/ ..." on page 563
SCPI command reference