Rohde & Schwarz R&S ZNA Series - Page 1656

Command reference
R&S
®
ZNA
1656User Manual 1178.6462.02 ─ 29
TRIGger<Ch>[:SEQuence]:MULTiple:LOGic <Sequence>[, <TrigLogic>]
Defines the logical combination of the trigger events defined in TRIGger<Ch>[:
SEQuence]:MULTiple:SOURce<inp> that will trigger measurement sequence
<Sequence>.
Suffix:
<Ch>
.
Channel number
Parameters:
<Sequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence
PPOint denotes "partial measurement"; see TRIGger<Ch>[:
SEQuence]:LINK.
<TrigLogic> NONE | AND | OR
NONE
only trigger event 1 is considered
AND
logical AND of trigger events 1 and 2
OR
logical OR of trigger events 1 and 2
Example:
TRIGger<Ch>:SOURce MULTiple
Activate multiple trigger mode.
:TRIG:MULTiple:SOUR1 SWE, EXTA; SOUR2 SWE, EXTB
Define Trigger In A and B as trigger sources for sweeps.
TRIG:MULT:SLOP1 SWE, POS; SLOP2 POIN, POS
Trigger on the rising edges of Trigger In A and B.
TRIG<Ch>:MULT:LOG SWE, AND
Trigger a new sweep if both trigger events have occurred.
TRIG:MULT:HOLD POIN, 1ms
Define a trigger delay of 1 ms before each sweep start.
Manual operation: See "... /Logic/ ..." on page 563
TRIGger<Ch>[:SEQuence]:MULTiple:SLOPe<Num> <MeasSequence>[, <Slope>]
Qualifies whether the multiple trigger events occur on the rising or on the falling edge
or on the beginning of the high / low level periods of the external TTL trigger signal
<Num>.
Suffix:
<Ch>
.
Channel number
<Num> Number of trigger signal (1 or 2)
Parameters:
<MeasSequence> SWEep | SEGMent | POINt | PPOint
Triggered measurement sequence, PPOint denotes "partial
measurement"; see TRIGger<Ch>[:SEQuence]:LINK.
SCPI command reference