Rohde & Schwarz R&S ZNA Series - Page 765

GUI reference
R&S
®
ZNA
765User Manual 1178.6462.02 ─ 29
Method
Selects the Delta-L+ characterization method to be used. Default is "Method 2L". For
background information, see Delta-L 4.0 PCB characterization.
"Method 1L" handles single-ended and balanced measurement results differently; acti-
vate "1L Diff. Mode" for balanced measurements. For "Method 2L" and "Method 3L"
measurements can also be single-ended or balanced, but the tool does not distinguish
between them.
Remote command:
CALCulate:FMODel:DELT:METHod
CALCulate:FMODel:DELT:M1L:DIFFmode
Measurements
Defines whether single-ended or balanced ports are measured for Delta-L characteri-
zations.
Remote command:
CALCulate:FMODel:DELT:MEASurement
Offset Embed softtool