Rohde & Schwarz R&S ZNA Series - Page 1030

Command reference
R&S
®
ZNA
1030User Manual 1178.6462.02 ─ 29
CALCulate:FMODel:DELT:MEASurement <Measurement>
Defines whether single-ended or balanced ports are measured for Delta-L characteri-
zations.
Parameters:
<Measurement> SINGleended | BALanced
SINGleended
Single-ended ports only
BALanced
Balanced ports only
*RST: SINGleended
Options: R&S ZNA-K231
Manual operation: See "Measurements" on page 765
CALCulate:FMODel:DELT:METHod
<Method>
Selects the Delta-L+ characterization method to be used.
Parameters:
<Method> M1L | M2L | M3L
One, two, or three line/length analysis
Options: R&S ZNA-K231
Manual operation: See "Method" on page 765
CALCulate:FMODel:DELT:PORDer <PortOrder>
Declares how the DUT is connected to the measurement system. Choosing the wrong
port ordering for your setup, can result in erroneous results.
Parameters:
<PortOrder> ODDeven | SEQuential
ODDeven
Ports 1, 3 and 2, 4 form input/output pairs
SEQuential
Ports 1, 2 and 3, 4 form input/output pairs
Options: R&S ZNA-K231
Manual operation: See "Port Order" on page 766
CALCulate:FMODel:DELT:RUN
Runs the AITT-DL tool with the collected measurement data and the configured Delta-L
settings.
Usage:
Event
SCPI command reference