Rohde & Schwarz R&S ZNA Series - Page 980

Command reference
R&S
®
ZNA
980User Manual 1178.6462.02 ─ 29
Example: Suppose that a TOSM calibration for ports 1 and 2 is active in
channel no. 1.
CALCulate:DATA:CALL:CATalog?
Query the traces available for CALCulate<Ch>:DATA:CALL?.
The response is 'S11,S12,S21,S22'.
CALCulate:DATA:CALL? SDATa
Return the complex response values of all traces. The traces in
the catalog list are read one after another: The response array
contains n (number of points) pairs of real and imaginary values
for S
11
, followed by n pairs of values for S
12
, S
21
, and S
22
.
CALCulate<Ch>:DATA:CALL:CATalog?
Returns all traces which are available for CALCulate<Ch>:DATA:CALL in channel
no. <Ch>. The response is a string parameter with all S-parameter traces in the current
channel or in the active system error correction; see example.
Suffix:
<Ch>
.
Channel number
Example: See CALCulate<Ch>:DATA:CALL
Usage: Query only
CALCulate<Ch>:DATA:CHANnel:ALL? <Format>
Reads the current response values of all traces of the selected channel.
Suffix:
<Ch>
.
Channel number
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
Return values:
<Data> Trace data either in ASCII or block data format, depending on
the current FORMat[:DATA] setting.
Usage: Query only
CALCulate<Ch>:DATA:CHANnel:DALL? <Format>
Reads the current response values of all data traces of the selected channel. Use
CALCulate<Ch>:DATA:CHANnel:ALL? to query data traces and memory traces.
Suffix:
<Ch>
.
Channel number
SCPI command reference