Command reference
R&S
®
ZNA
976User Manual 1178.6462.02 ─ 29
Note
●
The data format is parameter-dependent; see tables below. The unit is the default
unit of the measured parameter; see CALCulate<Ch>:PARameter:SDEFine.
●
Unformatted trace data (SDATa) can only be imported to memory traces
●
Formatted trace data (FDATa) can only be imported to "live" traces if the related
channel is in single sweep mode (INITiate<Ch>:CONTinuous OFF).
Before the import, the target trace must be prepared according to the settings used
during export. Any request for new data from the hardware ("Restart Sweep" in sin-
gle sweep mode or switching to continuous sweep mode) discards imported data
and switches back the display to measured data.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Data> Trace data either in ASCII or block data format, depending on
the current FORMat[:DATA] setting.
Parameters for setting and query:
<Format> FDATa | SDATa | MDATa | TSData | NCData | UCData |
SCORr1 | SCORr2 | SCORr3 | SCORr4 | SCORr5 | SCORr6 |
SCORr7 | SCORr8 | SCORr9 | SCORr10 | SCORr11 |
SCORr12 | SCORr13 | SCORr14 | SCORr15 | SCORr16 |
SCORr17 | SCORr18 | SCORr19 | SCORr20 | SCORr21 |
SCORr22 | SCORr23 | SCORr24 | SCORr25 | SCORr26 |
SCORr27
See list of parameters below.
Example:
*RST; SWE:POIN 20
Create a trace with 20 sweep points, making the created trace
the active trace of channel 1 (omitted optional mnemonic
SENSe1).
CALC:DATA? FDAT
Query the 20 response values of the created trace. In the FDATa
setting, 20 comma-separated ASCII values are returned.
CALC:DATA:STIM?
Query the 20 stimulus values of the created trace. 20 comma-
separated ASCII values are returned.
CALC2:PAR:SDEF 'Trc2', 'S11'
Create a second trace in a new channel no. 2. The second trace
does not become the active trace and is not displayed.
CALC:DATA:TRAC? 'Trc2', FDAT
Query the response values of the second (non-active) trace. 20
comma-separated ASCII values are returned.
CALC:DATA:ALL? FDAT
Query the response values of all traces. 40 comma-separated
ASCII values are returned.
SCPI command reference
To Next Page
Loading...
