Rohde & Schwarz R&S ZNA Series - Page 589

GUI reference
R&S
®
ZNA
589User Manual 1178.6462.02 ─ 29
●
The calibration can be invalid
"Default Port Assignment" restores the default port assignments.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine:TPORt
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:COUNt?
"Detect Port Assignment"
[SENSe:]CORRection:COLLect:AUTO:PORTs:CONNection?
"Default Port Assignment"
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:TPORt:
DEFault
Temperature Compensation ← Cal. Settings
Available for inline calibration systems (ICS) only. Applies to all inline calibration units
(ICUs) that are connected to the ICS and that are used with factory characterization
data.
If checked, the R&S ZNA firmware adjusts the factory characterization data according
to the ICU temperatures.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:TEMPcomp
Autoset Calibration
Resets the calibration to its default for the current channel mode.
Remote command:
n.a.
Repeat Cal
If checked, measurement data of the active calibration are reused (if available), which
allows the calibration to be repeated without repeating all measurements.
Remote command:
[SENSe<Ch>:]CORRection:COLLect:AUTO:REPeat
Import Cal Kit...
Opens the "Import Calibration Kit" dialog that allows you to import a cal kit file. For
background information, see Chapter 4.5.2.4, "Cal kit Files", on page 204.
Cal softtool