Command reference
R&S
®
ZNA
1360User Manual 1178.6462.02 ─ 29
Example: See Chapter 8.2.5.2, "MultiCal (with calibration unit)",
on page 1748
Usage: Query only
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:COUNt?
Returns the number of port assignments of the "current" calibration, i.e. the calibration
last created using [SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure.
This is particulary useful if the default port assignments were established using
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault.
See Chapter 4.5.5.6, "Multiple port assignments", on page 216 for background infor-
mation.
Note:
In MultiCal scenarios, use [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment:ALL:COUNt? to get the number of port assignments of all calibrations.
Suffix:
<Ch>
.
Channel number
Example: See [SENSe<Ch>:]CORRection:COLLect:AUTO:
ASSignment<Asg>:DEFine on page 1360
Usage: Query only
Manual operation: See "CalUnit Con" on page 588
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine
<TestPort1>, <CalUnitPort1>[, <TestPort2>]...
Manually defines port assignment no. <Asg> for channel no. <Ch>.
With manual configuration a non-minimal set of port assignments can be created,
which may increase measurement accuracy. On the other hand, it is up to the user to
ensure that the created set of port assignments is complete and valid for the chosen
calibration type (see [SENSe<Ch>:]CORRection:COLLect:AUTO:CONFigure).
Note that during the corresponding calibration sweep the R&S ZNA expects the physi-
cal port connections to be established exactly as defined by the port pairs.
Use
●
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment<Asg>:DEFine:
TPORt command to take advantage of auto-detection of port connections.
●
[SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:DEFault
or [SENSe<Ch>:]CORRection:COLLect:AUTO:ASSignment:DEFine:
TPORt:DEFault to create the default assignments instead.
See Chapter 4.5.5.6, "Multiple port assignments", on page 216 for background infor-
mation.
SCPI command reference
To Next Page
Loading...
