Rohde & Schwarz R&S ZNA Series - Page 1339

Command reference
R&S
®
ZNA
1339User Manual 1178.6462.02 ─ 29
Manual operation: See "Harmonic Orders to Calibrate" on page 590
[SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:REMove
Removes a harmonic order from the list of harmonic orders at which source and
receiver calibrations shall be performed for harmonics measurements in channel <Ch>.
Use [SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:REMove to get this
list, and [SENSe<Ch>:]CORRection:ADVanced:HARMonic:ORDer:ADD to add a
harmonic order to it.
Use SOURce<Ch>:POWer<PhyPt>:CORRection:HARMonic[:ACQuire] and
[SENSe<Ch>:]CORRection:POWer<PhyPt>:HARMonic:ACQuire) to calibrate.
Suffix:
<Ch>
.
Channel number
Usage: Event
Options: R&S ZNA-K4
Manual operation: See "Harmonic Orders to Calibrate" on page 590
[SENSe<Ch>:]CORRection:ADVanced:POWer<PhyPt> <Power>
Suffix:
<Ch>
.
<PhyPt>
Parameters:
<Power> Default unit: dBm
Manual operation: See "Cal Power" on page 593
[SENSe<Ch>:]CORRection:ADVanced:POWer<PhyPt>:STATe <Boolean>
Suffix:
<Ch>
.
<PhyPt>
Parameters:
<Boolean>
Manual operation: See "Cal Power" on page 593
[SENSe<Ch>:]CORRection:ADVanced:SENSe<PhyPt>:ATTenautor <Attenuation>
Suffix:
<Ch>
.
<PhyPt>
SCPI command reference