Rohde & Schwarz R&S ZNA Series - Page 1094

Command reference
R&S
®
ZNA
1094User Manual 1178.6462.02 ─ 29
The marker's stimulus value can be set using
CALCulate<Chn>:MARKer<Mk>:X or
CALCulate<Chn>:MARKer<Mk>:REFerence:X; the marker
automatically follows the trace.
FIXed: freezes the marker at the position determined by the cur-
rent stimulus and response value. The response value stored
with the marker is not adjusted to subsequent sweeps. Tracking
is disabled. Stimulus and response value are stored with the
marker; they are not adjusted to subsequent sweeps and trace
format changes.
The marker stimulus can be set using
CALCulate<Chn>:MARKer<Mk>:X or
CALCulate<Chn>:MARKer<Mk>:REFerence:X, but the
response value remains fixed.
ARBitrary: freezes the marker at the position determined by the
current stimulus and response value. Tracking is disabled. The
marker stores the stimulus value and – in addition – its X and Y
coordinates in the current marker format (see
CALCulate<Chn>:MARKer<Mk>:FORMat or
CALCulate<Chn>:MARKer<Mk>:REFerence:FORMat).
The marker position can be set using
CALCulate<Chn>:MARKer<Mk>:X and
CALCulate<Chn>:MARKer<Mk>:Y or
CALCulate<Chn>:MARKer<Mk>:REFerence:X and
CALCulate<Chn>:MARKer<Mk>:REFerence:Y. If, in the cur-
rent trace format, the X axis represents the stimulus, the mark-
er's stimulus value is adjusted accordingly. Otherwise the mark-
er's stimulus value remains unchanged. Switching between
trace formats resets the marker position to the response value at
the marker's stimulus value.
*RST:
NORMal
Example:
CALC:MARK ON; :CALC:MARK:TYPE FIX
Create marker 1 and display it in the center of the sweep range
as a fixed marker.
CALC:MARK:X 1GHz
Shift the marker horizontally. The response value remains fixed.
Manual operation: See "Marker Mode" on page 502
CALCulate<Chn>:MARKer<Mk>:X <StimulusValue>[, <Seg>[, <MeasPoint>]]
CALCulate<Chn>:MARKer<Mk>:REFerence:X <StimulusValue>[, <Seg>[,
<MeasPoint>]]
Defines the stimulus value of the related marker (see "Marker addressing"
on page 1073).
If the marker's mode is NORMal or FIXed (see CALCulate<Chn>:MARKer<Mk>:
TYPE or CALCulate<Chn>:MARKer<Mk>:REFerence:TYPE), this command sets or
gets the marker's stimulus value.
SCPI command reference