Rohde & Schwarz R&S ZNA Series - Page 1100

Command reference
R&S
®
ZNA
1100User Manual 1178.6462.02 ─ 29
CALCulate<Chn>:MATH:STATe <Boolean>
CALCulate<Chn>:MATH:FORMatted:STATe <Boolean>
Activates or deactivates trace math for unformatted and/or formatted trace data, i.e. the
trace formulae defined via CALCulate<Chn>:MATH[:EXPRession]:SDEFine
and/or CALCulate<Chn>:MATH:FORMatted[:EXPRession]:SDEFine, respec-
tively.
When trace math is active either for unformatted or formatted data, the resulting math-
ematical trace is calculated and displayed instead of the active data trace.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON – apply trace math on the
OFF – display the active data trace
*RST: OFF
Example:
*RST; :CALC:MATH:MEM
Copy the current state of the default trace 'Trc1' to a memory
trace named 'Mem2[Trc1]'. The memory trace is not dis-
played.
CALC:MATH:SDEF 'Trc1 / Mem2[Trc1]'
Define a mathematical trace, dividing the complex data trace by
the stored complex memory trace. The mathematical trace is not
displayed.
CALC:MATH:STAT ON
Display the mathematical trace instead of the active data trace.
Manual operation: See "Trace Math" on page 443
CALCulate<Chn>:MATH:WUNit[:STATe] <Boolean>
Controls the conversion and formatting of the mathematic expression defined via
CALCulate<Chn>:MATH[:EXPRession]:SDEFine.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Parameters:
<Boolean> ON –"Result is Wave Quantity" enabled: the analyzer assumes
that the result of the mathematical expression represents a volt-
age.
OFF –"Result is Wave Quantity" disabled: the analyzer assumes
that the result of the mathematical expression is dimensionless.
*RST: OFF
SCPI command reference