Rohde & Schwarz R&S ZNA Series - Page 1445

Command reference
R&S
®
ZNA
1445User Manual 1178.6462.02 ─ 29
Suffix:
<Ch>
.
Channel number
Parameters:
<Address> Use SENSe:GDEVice:ADDRess? to get the address strings of
the configured generic devices.
If omitted as a parameter, the query returns all generic device
calibration mixer command configurations of channel <Ch>.
As a return value, <Adress> takes the long form described in
Table 5-13, with an additional prefix GenericDevice:: (see
example).
<CommandFilepath> Path to the command file, either absolute or relative to the cur-
rent directory (see MMEMory:CDIRectory).
<MixerCommandId> A unique "Command Name" (see Chapter 5.19.9, "Generic
Device tab", on page 921) within command file <CommandFile-
path>.
Manual operation: See "Generic Device Setting for Calibration Mixer" on page 591
[SENSe<Ch>:]GDEVice:SELect <Address>, <CommandFilepath>, <CommandId>
Defines or queries the generic device command configuration of channel <Ch>.
Suffix:
<Ch>
.
Channel number
Parameters:
<Address> Use SENSe:GDEVice:ADDRess? to get the address strings of
the configured generic devices.
If omitted as a parameter, the query returns all generic device
command configurations of channel <Ch>.
As a return value, <Adress> takes the long form described in
Table 5-13, with an additional prefix GenericDevice:: (see
example).
<CommandFilepath> Path to the command file, either absolute or relative to the cur-
rent directory (see MMEMory:CDIRectory).
<CommandId> A unique "Command Name" (see Chapter 5.19.9, "Generic
Device tab", on page 921) within command file <CommandFile-
path>.
SCPI command reference