Rohde & Schwarz R&S ZNA Series - Page 1587

Command reference
R&S
®
ZNA
1587User Manual 1178.6462.02 ─ 29
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via <Gen>.
<Gen> Generator number
Parameters:
<arg0> ON | OFF: Enable or disable the power limit.
*RST: The power limit settings are not changed after a
*RST. The factory setting is OFF.
Example: See SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:
LLIMit:VALue on page 1588
Manual operation: See "Port Power Limits" on page 869
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit:VALue <arg0>
Defines a limit for the source power of an external generator no. <Gen>. The limit must
be enabled explicitly using
SOURce<Ch>:POWer<PhyPt>:GENerator<Gen>:LLIMit[:STATe].
Suffix:
<Ch>
.
Channel number. This suffix is ignored; the limit applies to all
channels.
<PhyPt> Test port number of the analyzer. This suffix is ignored; the gen-
erator is selected via <Gen>.
<Gen> Generator number
Parameters:
<arg0> Limit for the generator power.
Range: Depending on the generator model.
Increment: 0.1-dB
*RST: The power limit is not changed after a *RST. The
factory setting is 0 dBm.
Default unit: dBm
Example: See SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate]:
LLIMit:VALue on page 1588
Manual operation: See "Port Power Limits" on page 869
SOURce<Ch>:POWer<PhyPt>[:LEVel][:IMMediate][:AMPLitude] <IntSourcePow>
Defines the power of the internal signal source (channel base power). The setting is
valid for all sweep types, except power sweep.
Tip: Use SOURce<Ch>:POWer<PhyPt>:STARt and SOURce<Ch>:POWer<PhyPt>:
STOP to define the sweep range for a power sweep.
Suffix:
<Ch>
.
Channel number
SCPI command reference