Rohde & Schwarz R&S ZNA Series - Page 1684

Command reference
R&S
®
ZNA
1684User Manual 1178.6462.02 ─ 29
Decimal value
Number of bytes the follow in the <Binary data> part
<Binary data>
Binary data in ASCII format
Example: //Return system information
DIAG:HUMS:SYST:INFO?
Usage: Query only
DIAGnostic:HUMS:SYSTem:STATus?
Queries the complete system status information of the instrument. Depending on the
set data format, the queried data is either displayed in XML or JSON format. For more
information about setting the data format, see DIAGnostic:HUMS:FORMat
on page 1679.
Return values:
<SystemStatus> <block_data>
Returns complete system status information of the connected
instrument as block data in a comma-separated list:
#blockdata{<globalStatus>,<tablevalues>:
[{tablevalue1},{tablevalue2},...]}
Binary block data with the following syntax:
#<Digits><Length><Binarydata>
#
Indicates the start of the binary block
<Digits>
Decimal value
Gives the number of decimal digits used for the <Length>
value
<Length>
Decimal value
Number of bytes the follow in the <Binary data> part
<Binary data>
Binary data in ASCII format
For each table value it returns the following values:
<id>,<description>,<descriptionExtended>,
<value>,<unit>,<upperLimit>,<lowerLimit>,
<reference>,<severity>
Example:
//Return system status information
DIAG:HUMS:SYST:STAT?
#41874{"globalStatus":3,"values":[{"id":
31522816,"description":
"RF Overload","descriptionExtended":
null,"value":null,"unit":null,"upperLimit":
null,"lowerLimit":null,"reference":
null,"severity":1},...}]}
Usage: Query only
HUMS and service date commands