Rohde & Schwarz R&S ZNA Series - Page 1703

Command reference
R&S
®
ZNA
1703User Manual 1178.6462.02 ─ 29
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number (ignored for reference markers)
Usage: Event
CALCulate<Chn>:MARKer<Mk>:SEARch:LEFT
CALCulate<Chn>:MARKer<Mk>:SEARch:NEXT
CALCulate<Chn>:MARKer<Mk>:SEARch:RIGHt
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:LEFT
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:NEXT
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch:RIGHt
These commands selects a search mode for the related marker (see "Marker address-
ing" on page 1073), and initiate a search for the next valid peak to the left, the next
highest or lowest value among the valid peaks, and the next valid peak to the right.
The marker must be created before using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON or CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe] ON.
Note: These commands are the ZVR-compatible equivalents of CALCulate<Chn>:
MARKer<Mk>:FUNCtion:EXECute LPEak | NPEak | RPEak and
CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:EXECute LPEak |
NPEak | RPEak.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
<Mk> Marker number (ignored for reference markers)
Usage: Event
CALCulate<Chn>:MARKer<Mk>:SEARch[:IMMediate]
CALCulate<Chn>:MARKer<Mk>:REFerence:SEARch[:IMMediate]
Initiates a search for the related marker (see "Marker addressing" on page 1073).
Before using this command:
●
The marker must be created using CALCulate<Chn>:MARKer<Mk>[:STATe]
ON or CALCulate<Chn>:MARKer<Mk>:REFerence[:STATe] ON.
●
The search function must be selected using CALCulate<Chn>:MARKer<Mk>:
FUNCtion[:SELect] or CALCulate<Chn>:MARKer<Mk>:REFerence:
FUNCtion[:SELect].
Note: Together with CALCulate<Chn>:MARKer<Mk>:FUNCtion[:SELect] and
CALCulate<Chn>:MARKer:REFerence:FUNCtion[:SELect], these commands
are the ZVR-compatible equivalents of CALCulate<Chn>:MARKer<Mk>:FUNCtion:
EXECute and CALCulate<Chn>:MARKer<Mk>:REFerence:FUNCtion:EXECute.
Suffix:
<Chn>
.
Channel number used to identify the active trace.
R&S ZVR/ZVABT compatible commands