Rohde & Schwarz R&S ZNA Series - Page 343

GUI reference
R&S
®
ZNA
343User Manual 1178.6462.02 ─ 29
"Meas" softtool tab Channel Mode Required Software Option
Power Sensor tab - -
Spectrum tab Spectrum R&S ZNA-K1
External DLL tab -
Mixer Params (Frequency Converting DUTs)
All frequency converting measurements require software option R&S ZNA-K4 (see
Chapter 4.7.3, "Frequency conversion measurements", on page 261). If this option is
not available, the "Mixer Params" measurement type and the corresponding tabs are
not available.
Table 5-3: Meas softtool for Mixer Params Measurements
"Meas" softtool tab Channel Mode Required Software Option
(in addition to R&S ZNA-K4)
Scalar Mixer Meas tab Scalar mixer measurements -
Vector Mixer Meas tab Vector mixer measurements R&S ZNA-K5
Two Tone Group Dly tab (fre-
quency-converting DUT)
Embedded LO mixer group delay
measurements
R&S ZNA-K9
Noise Figure tab Noise figure measurement R&S ZNA-K30
Meas softtool