Rohde & Schwarz R&S ZNA Series - Page 83

Getting Started
R&S
®
ZNA
83User Manual 1178.6462.02 ─ 29
Table 3-7: Shipment of VNA system R&S
ZNA67EXT, order no. 1352.1888Kxx (Variants xx = 02, ..., 07)
Variant 02 Variant 05 Variant 03 Variant 06 Variant 04 Variant 07
VNA R&S ZNA67, 1.85 mm order no. 1332.4500Kyy Shipment: see R&S ZNA Getting Started
1
2-port (variant 62) 4-port (variant 64)
Converter R&S ZVA-Z110, WM-2540 (WR10)
order no. 1352.1642.yy
2,3,4
2 x std. power (variant 40)
2 x high power (variant 50)
2 x std. power (variant 40)
2 x high power (variant 50)
4 x std. power (variant 40)
4 x high power (variant 50)
Diplexer R&S ZVA-ZD110
order no. 1314.4002.yy
2,4,5
1 x left (variant 12), 1 x right (variant 18)
2 x left (variant 12), 2 x right (variant 18)
5
Torque wrench for diplexer test port 1 x R&S ZN-ZTW variant 12, 1 mm, 0.34 Nm, order no. 1328.8534.12 LO power divider SMA (f) 27 GHz
+ angled SMA adapters (m/f) R&S ZV-Z1218
(order no. 1314.5380.00)
1 x 1:2 R&S ZV-Z1227 (order no. 1307.0886.02) + 2 adapters
1 x 1:4 R&S ZV-Z1228 (order no. 3626.4937.02)
+ 4 adapters
H/L SWITCH control cable 1 x for control of 2 diplexers, 2.5 m, order no. 1312.6643.00 1 x for control of 4 diplexers, 2.5 m, order no. 1352.1688.00
VNA R&S ZNA67EXT Getting Started (this document)
1 x
1
: For mandatory options, see Chapter 3.5.4.1, "Vector network analyzer R&S ZNA67", on page 85.
2
: The converters are pre-mounted to the diplexers.
3
: Each converter is delivered with an external 9 V DC power supply, and with IF cables R&S CABLE EXT REF and R&S CABLE EXT MEAS.
4
: The required RF and LO cables are not part of the standard delivery. They can be ordered separately, see "Cable sets (optional)" on page 98.
5
: With cable deflectors premounted to the "outer" diplexer
Getting started with R&S ZNA67EXT