GUI reference
R&S
®
ZNA
915User Manual 1178.6462.02 ─ 29
Unusable matrix test ports are marked with an "x". If the result does not suit your
needs, consider the switchable paths of your matrix and adjust the matrix VNA port
connections (see Chapter 4.7.41.3, "RF connections and matrix connectivity",
on page 325). Then select "Renumber Test Ports" again.
You can tweak the resulting test port assignment by renumbering the test ports and/or
setting some of the matrix test ports to "Unused" (see "Edit Test Port Connection"
on page 917). Configuration errors are displayed in balloon popups appearing at the
lower left corner of the dialog.
A redefinition of the physical VNA ports (see Chapter 5.19.8.2, "Define Physical Ports
dialog", on page 919) causes a factory reset and deletes all switch matrix RF connec-
tions. So the RF configuration for switch matrices has to be done after the port redefini-
tion.
Add
Opens the "Add Switch Matrix" dialog:
Select the required matrices and tap "OK" to add them to the RF connection configura-
tion or tap "Cancel" to quit the dialog without adding a switch matrix to the RF connec-
tion configuration
Note:
●
This dialog is shown automatically, in case no matrix has been added to the RF
connection configuration yet.
●
If the RF configuration already contains all registered switch matrices, the "Add"
button is disabled.
Remote command:
n.a.
Delete
Opens the "Delete Switch Matrix" dialog:
Setup softtool
To Next Page
Loading...
