GUI reference
R&S
®
ZNA
924User Manual 1178.6462.02 ─ 29
LAN Detection
Activate "LAN Detection" to include the LAN interface in the autodetection sequence
(see Scan Instruments).
Note: "LAN detection" only works for external devices sharing the IP subnet with the
R&S ZNA.
As a prerequisite, the R&S ZNA must accept incoming connections on UDP port 2473.
If necessary, add a corresponding inbound rule to your firewall settings.
Remote command:
n/a
Add Device
Opens the "Add Generic Device" dialog that allows you to configure the connection to
a generic device that was not auto-detected. The configured device is added to the list
of "Configured Devices".
The connection is defined with the following settings:
●
"Interface" selects an interface/protocol type for the connection. In addition to the
VXI-11, SOCKET, and GPIB interfaces, the analyzer supports any "Other" interface
supported by the installed VISA library.
USB-VISA devices are auto-detected and hence this interface type does not show
up here.
●
"Address" contains the address for the current interface type. GPIB addresses
must be unique for all devices connected to the GPIB bus (range: 0 to 30), GPIB
and IP addresses must agree with the entries in the VISA library. The remaining
interface types require composite address formats; see Table 5-13.
●
"Identify" sends an identification query ("IDN?") to the specified device address to
identify the model and serial number of the connected device.
Setup softtool
To Next Page
Loading...
