(1) Remove the power steering pump from the
engine. Refer to the procedure in the Removal And
Installation Section in this group of the service man-
ual.
(2) Remove the 3 bolts (Fig. 15) mounting the
power steering fluid reservoir to the power steering
pump.
(3) Separate the power steering fluid reservoir
from the power steering pump (Fig. 16). The reser-
voir is separated from the power steering pump by
pulling it straight out of the pump.
INSTALL
(1) Lubricate the O-ring seal on the power steering
fluid reservoir (Fig. 17) with fresh clean power steer-
ing fluid.
(2) Install the power steering fluid reservoir on the
power steering pump (Fig. 16). The reservoir is
installed on the pump by pressing the nipple of the
reservoir straight into the pump without twisting or
rotating the reservoir.
(3) Install and securely tighten the three bolts
mounting the power steering fluid reservoir to the
power steering pump. Tighten bolt on pulley side to
13 N·m (115 in. lbs.). Tighten bolts on rear to 24 N·m
(212 in. lbs.).
(4) Install the power steering pump on the engine.
Refer to the procedure in the Removal And Installa-
tion Section in this group of the service manual
POWER STEERING PUMP PULLEY
DISASSEMBLE
CAUTION: When mounting the power steering
pump in the vise do not clamp the pump in the vise
by the body of the power steering pump.
(1) Mount the power steering pump in a vise using
the mounting bosses for the power steering pump
(Fig. 18).
NOTE: Do not press or hammer on the shaft of the
power steering pump in an attempt to remove the
pulley. This will damage the internal components of
the power steering pump.
Fig. 15 Fluid Reservoir To Pump Mounting
1 – POWER STEERING FLUID RESERVOIR
2 – MOUNTING BOLTS
3 – POWER STEERING PUMP
4 – MOUNTING BOLT
Fig. 16 Fluid Reservoir Removal/Installation
1 – POWER STEERING FLUID RESERVOIR
2 – POWER STEERING PUMP
Fig. 17 Reservoir O-Ring Seal
1 – POWER STEERING FLUID RESERVOIR
2 – O-RING
19 - 26 STEERING LH
DISASSEMBLY AND ASSEMBLY (Continued)
To Next Page
Loading...
