REMOVAL AND INSTALLATION
SERVICE WARNINGS AND CAUTIONS
WARNING: POWER STEERING OIL, ENGINE COM-
PONENTS AND THE EXHAUST SYSTEM MAY BE
EXTREMELY HOT IF ENGINE HAS BEEN RUNNING.
DO NOT START ENGINE WITH ANY LOOSE OR DIS-
CONNECTED HOSES OR DRIVE BELTS. DO NOT
ALLOW HOSES TO TOUCH HOT EXHAUST MANI-
FOLD OR CATALYST.
CAUTION: While disconnected, cap all open ends
of the power steering fluid hose connections. This
will prevent the entry of foreign material into the
components when power steering hoses are
removed.
POWER STEERING GEAR
NOTE: Before proceeding, review SERVICE WARN-
INGS AND CAUTIONS found at the beginning of the
REMOVAL AND INSTALLATION section.
REMOVAL
(1) Remove the battery ground cable from the
ground stud on the shock tower and isolate the
ground cable by installing the cable isolator on the
ground stud (Fig. 3).
(2) Position the front tires of the vehicle so that
they are facing straight ahead.
(3) Raise the vehicle on a frame contact type hoist
until the front tires of the vehicle are just off the
floor. See Hoisting in the Lubrication and Mainte-
nance section of this manual for the required lifting
procedure to be used for this vehicle.
(4) Remove caps from both wiper arms at the
attachment to the pivots to expose the wiper arm
attaching nut. Remove the nut (Fig. 4) attaching
each wiper arm to its pivot
(5) Remove the wiper arms from the pivots. Wiper
arms are removed from the pivots by rocking them
back and force on the pivots until they can be pulled
off the pivots.
(6) Remove the wiper module cover and cowl cover
(Fig. 5) from the vehicle.
Fig. 3 Correctly Isolated Remote Ground Cable
1 – CABLE ISOLATOR
2 – GROUND STUD
3 – GROUND CABLE
Fig. 4 Wiper Arm Attachment To Pivot
1 – WIPER ARMS
2 – ATTACHING NUT
3 – ATTACHING NUT
Fig. 5 Wiper Module And Cowl Cover
1 – COWL COVER
2 – WIPER MODULE COVER
LH STEERING 19 - 31
To Next Page
Loading...
