(4) Remove the steering column upper shroud from
the steering column using the following procedure:
First, on the right seam between the upper and lower
shrouds, push in on seam at the forward end. When
the upper shroud unsnaps, pull the upper shroud
upward away from the lower. Repeat this procedure
on the opposite side of the column to release the
upper shroud from the lower. Remove the upper
shroud from the steering column.
(5) Remove the tilt lever (Fig. 68) from the steer-
ing column.
(6) Remove the 2 screws attaching the lower
shroud to the steering column (Fig. 69). Remove the
lower shroud from the steering column.
(7) Disconnect the wiring harness connector from
the brake transmission shift interlock (BTSI) sole-
noid (Fig. 70).
(8) Remove the retainer clip from the end of the
BTSI solenoid (Fig. 71).
(9) Slide the BTSI solenoid straight off the shift
lever mounting stud.
INSTALLATION
(1) Align the flat inside the brake transmission
shift interlock (BTSI) solenoid (Fig. 72) with the flat
on the shift lever mounting stud.
(2) Slide the solenoid completely onto the shift
lever mounting stud aligning the plastic guide
formed into the solenoid housing with the flange on
the shift lever mechanism bracket (Fig. 73).
Fig. 66 Fuse Panel Cover
1 – FUSE PANEL COVER
2 – INSTRUMENT PANEL
Fig. 67 Lower Instrument Panel Cover Mounting
Screws
1 – MOUNTING SCREWS
2 – INSTRUMENT PANEL BRACKET
3 – LOWER INSTRUMENT PANEL COVER
Fig. 68 Tilt Lever
1 – TILT LEVER
2 – LOWER SHROUD
Fig. 69 Lower Shroud Attaching Screws
1 – LOWER SHROUD
2 – MOUNTING SCREWS
LH 42LE TRANSAXLE 21 - 41
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
