Chrysler 2000 LHS - Page 1422

(2) Press on the side panel to seat clips.
(3) Install attaching screws.
(4) Install floor console shift bezel.
(5) Install shift knob.
FLOOR CARPET
REMOVAL
(1) Remove floor mats.
(2) Remove door sill trim covers.
(3) Remove cowl side trim covers.
(4) Remove front seats.
(5) Remove bolts attaching front seat belt lower
anchors to floor below B-pillar trim panels.
(6) Remove center console, if equipped.
(7) Remove rear seat cushion.
(8) Remove gas pedal bracket.
(9) Remove carpet fasteners.
(10) Remove carpet from vehicle (Fig. 86).
INSTALLATION
(1) Place carpet in proper position on floor of vehi-
cle.
(2) Install carpet fasteners.
(3) Using double back tape or hook and loop,
secure carpet strap behind the instrument panel cen-
ter support bracket.
(4) Install cowl side trim covers.
(5) Install door sill trim covers.
(6) Install rear seat cushion.
(7) Install gas pedal bracket.
(8) Install center console, if equipped.
(9) Install bolts to attach seat belt lower anchors
to floor below B-pillar trim panels.
(10) Install front seats.
(11) Install floor mats.
SUN VISOR
All vehicles with driver and passenger side air
bags must have a colored coded five Bullet point air
bag warning label applied to the sun visor, verify
label availability and ensure the label is installed.
REMOVAL
(1) Remove screw attaching inboard visor retainer
to over head. (Fig. 87).
(2) Remove screws holding outboard visor pivot
base to roof.
(3) Disconnect visor vanity lamp wire connector, if
equipped.
(4) Remove visor from vehicle.
INSTALLATION
(1) Engage visor vanity lamp wire connector, if
equipped.
(2) Place visor in position on header.
(3) Install screws to attach outboard visor pivot
base to over head.
(4) Install screw to attach inboard visor retainer to
over head.
FRONT ASSIST HANDLE
REMOVAL
(1) Pull and hold assist handle down.
(2) Remove screws attaching assist handle to roof
(Fig. 88).
(3) Remove assist handle from vehicle.
INSTALLATION
(1) Place assist handle in position on vehicle.
(2) Install screws to attach assist handle to roof.
Fig. 86 Floor Carpet
1 – REAR SEAT HOLDDOWN CUPS
2 – FLOOR CARPET
3 – FLOOR
Fig. 87 Sun Visor
1 – VISOR PIVOT BASE
2 – WIRE CONNECT
3 – RETAINER
4 – VISOR
LH BODY 23 - 71
REMOVAL AND INSTALLATION (Continued)