(12) Remove seat back foam and cover from frame.
(13) Disengage velcro from cover. With one hand,
hold velcro that is glued to seat back foam. With the
other hand, grasp opposite velcro strip and pull apart
to separate. This will prevent tearing velcro out of
seat back foam.
(14) Pull cover up far enough to access the remain-
ing three hog rings. Cut hog rings from cover.
(15) Remove cover from seat back foam.
INSTALLATION
(1) Position cover on seat back foam.
Fig. 16 Front Seat Back Panel
1 – FRONT SEAT BACK PANEL
Fig. 17 Seat Back J-strap Position & Orientation
1 – TRIM COVER J-STRAPS
2 – SEAT HEATER WIRE HARNESS
3 – SEAT AIRBAG WIRE HARNESS
Fig. 18 Recliner Attaching Bolt
1 – RECLINER BOLT
Fig. 19 Seat Airbag Module Electrical Connector
Location
1 – AIRBAG MODULE NYLON SLEEVE
2 – AIRBAG MODULE
3 – AIRBAG MODULE ELECTRICAL CONNECTOR
LH BODY 23 - 9
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
