FRONT SEAT ADJUSTER – POWER SEAT
AIRBAG EQUIPPED
REMOVAL
WARNING: DISCONNECT AND ISOLATE THE NEG-
ATIVE BATTERY CABLE REMOTE TERMINAL
BEFORE BEGINNING ANY FRONT SEAT REMOVAL
OR INSTALLATION PROCEDURE. THIS WILL DIS-
ABLE THE AIRBAG SYSTEM. FAILURE TO DISCON-
NECT THE BATTERY COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSI-
BLE PERSONAL INJURY.
WARNING: ONCE THE NEGATIVE CABLE IS DIS-
CONNECTED WAIT FOR 2 MINUTES BEFORE
REMOVING ANY AIRBAG SYSTEM COMPONENTS.
(1) Disconnect and isolate the remote negative bat-
tery cable.
(2) Remove the front seat back. Refer to the proce-
dure in this group.
(3) Remove bolts attaching seat adjuster to cush-
ion pan (Fig. 24).
(4) Disconnect wire harness from cushion pan.
(5) Remove seat adjuster from seat cushion.
INSTALLATION
(1) Place seat adjuster in position on seat cushion
pan.
(2) Connect wire harness to the cushion pan.
(3) Install bolts attaching seat adjuster to cushion
pad.
(4) Install seat back. Refer to the procedure in this
group.
(5) Install bolt to attach seat back recliner to seat
back on each side of seat. Tighten bolt to 8 N·m (71
in. lbs.) torque.
(6) Connect the negative battery cable.
(7) Using the DRB III Scan Tool erase all DTC’s
and perform airbag system diagnostics.
Fig. 23 Seat Back J-strap Position & Orientation
1 – TRIM COVER J-STRAPS
2 – SEAT HEATER WIRE HARNESS
3 – SEAT AIRBAG WIRE HARNESS
Fig. 24 Front Seat Track – Typical
1 – ATTACHING BOLTS
LH BODY 23 - 11
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
