(3) Remove the tail lamp assembly from the vehi-
cle (Fig. 9).
(4) Disconnect the tail lamp assembly electrical
connector.
Installation
(1) Connect the tail lamp assembly electrical con-
nector.
(2) Install the tail lamp assembly into the vehicle.
(3) Install the tail lamp assembly attaching nuts.
REAR LICENSE PLATE LAMP
Removal
(1) Remove the screws attaching the rear license
plate lamp to the rear bumper fascia.
(2) Remove the license plate lamp from the rear
bumper fascia (Fig. 10).
(3) Twist and remove the socket from the lamp
(Fig. 11).
Installation
(1) Install the socket into the lamp.
(2) Place the license plate lamp in position in the
rear bumper fascia.
(3) Install the screws attaching the rear license
plate lamp to the rear bumper fascia.
Fig. 9 Tail Lamp Assembly
1 – REAR TAIL LAMP ASSEMBLY
Fig. 10 Rear License Plate Lamp
1 – REAR LICENSE PLATE LAMPS
Fig. 11 Rear License Plate Lamp Socket
1 – LICENSE PLATE LAMP
2 – TRUNK LID
3 – SOCKET
4 – BULB
8L - 18 LAMPS LH
REMOVAL AND INSTALLATION (Continued)
2000 LHS, 300M, CONCORDE AND INTREPID
To Next Page
Loading...
