HEIDENHAIN iTNC 530 HSCI - Page 1010

1010 HEIDENHAIN Technical Manual iTNC 530 HSCI
 Counting direction of the motor encoder (DIRECT.)
 Maximum temperature (T-MAX) in °C
 Maximum current (I-MAX) in A
 Rated power output (P-N) in W
 Motor mass moment of inertia (J) in kgm
2
 Inductance of the series reactor (L) in µH
 Thermal time constant for direct current (T-DC) in seconds
 Lower thermal limit frequency (F-DC) in Hz
 Thermal time constant for alternating current (T-AC) in seconds
 Upper thermal limit frequency (F-AC) in Hz; above this frequency, the
maximum current I-MAX applies
 Thermal time constant for winding (Tth1) in s
 Thermal resistance between winding and lamination (Rth1) in K/W
 Thermal time constant for lamination (Tth2) in s
 Thermal resistance between lamination and coolant (Rth2) in K/W
 Stall torque (M0) in [Nm]
The entry is currently not yet evaluated, however.
 Torque (Mmax) at Imax in [Nm]
The entry is currently not yet evaluated, however.
 Direct inductance (Ld) in [mH]
The entry is currently not yet evaluated, however.
 Quadrature inductance (Ld) in [mH]
The entry is currently not yet evaluated, however.
 Recommended PWM frequency of the motor (Fpwm) in [Hz]
The entry is currently not yet evaluated, however.
 Current controller factor (Kp) in [V/A] calculated from the motor data
The entry is currently not yet evaluated, however.
 Current controller factor (Ki) in [V/A/s] calculated from the motor data
The entry is currently not yet evaluated, however.
 Type of temperature sensor (TempSens)
The entry is currently not yet evaluated, however.
 Iron loss resistance [Rfe] in [ohms]
The entry is currently not yet evaluated, however.