HEIDENHAIN iTNC 530 HSCI - Bit Set (Bs); Initial State: Double Word D8; Double Word D12; Function

1808 HEIDENHAIN Technical Manual iTNC 530 HSCI
9.8.56 BIT SET (BS)
Syntax: BS (BIT SET)
Operands: B, W, D, K, X
Action:
With the BIT SET command you can set each bit in the accumulator to 1. The
corresponding bits are selected (addressed) by the content of the specified
operand or by a constant. As to the bit numbering, bit 0 = LSB and bit 31 =
MSB. For operand contents greater than 32, the iTNC uses the operand value
modulo 32, i.e. the integral remainder of the result of the operand value
divided by 32.
Example:
Load double word D8 into the accumulator, set bit 0 of the accumulator to 1,
and save the result in double word D12.
Initial state:
Double word D8 = 3E 80 (hex)
Double word D12 = ?
Function STL Accumulator
content
Operand content
Load the double word D8
into the word accumulator
L D8 3E80 3E80
Set the bit specified in the
operand to 1.
BS K+0 3E81
Assign the result to
double word D12.
= D12 3E81 3E81