HEIDENHAIN iTNC 530 HSCI - Module 9304 Copy Columns P1 to P5 to the Pocket Table

1584 HEIDENHAIN Technical Manual iTNC 530 HSCI
Error code:
Module 9304 Copy columns P1 to P5 to the pocket table
Module 9304 transfers the contents of columns P1 to P5 from the pocket table
to the defined double-word address.
Call:
PS B/W/D/K <Magazine number>
PS B/W/D/K <Pocket number>
PS B/W/D/K <Double-word address>
CM 9304
Error code:
Marker Value Meaning
M4203 0 Selection complete
1 Error code in W1022
W1022 1 Line in the pocket table could not be found
2 Invalid magazine number
3 Invalid mode
4 Invalid tool number or type
6 Tool number is already contained in the pocket table
20 Module was not called in a submit or spawn job
36 File error in the tool or pocket table
45 Module execution canceled, see return value for error
Marker Value Meaning
M4203 0 Columns copied
1 Error code in W1022
W1022 1 Invalid pocket number
2 Invalid magazine number
4 Invalid double-word address
20 Module was not called in a submit or spawn job
36 File error in pocket table