HEIDENHAIN iTNC 530 HSCI - Position Display of the Tool Axis; Position Display Step

1148 HEIDENHAIN Technical Manual iTNC 530 HSCI
Position
display step
To define the position display step for axis and spindle positions:
 Enter the desired display step for the axes in MP7290.x and for the spindle
in MP7289.
The position loop resolution is not influenced by this parameter.
MP7290.x Position display step for the axes
Input: 0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.0005 mm or 0.0005°
6: 0.0001 mm or 0.0001°
MP7289 Position display step for the spindle
Input: 0: 0.1°
1: 0.05°
2: 0.01°
3: 0.005°
4: 0.001°
5: 0.0005°
6: 0.0001°
Position display of
the tool axis
The tool length can be offset in the position display of the tool axis. If it is, the
displayed position value then refers to the tool point:
 With MP7285, select whether the tool length should be offset.
The behavior of an incremental block after a TOOL CALL can be specified:
 With MP7682 bit 0, select whether the tool length should be offset.
MP7285 Tool length offset in the tool-axis position display
Input: 0: Tool length is not offset
1: Tool length is offset
MP7682 Machine parameter with multiple function
Input: Bit 0 – Incremental block after TOOL CALL
0: With length compensation
1: Without length compensation