692 HEIDENHAIN Technical Manual iTNC 530 HSCI
Perform the measurement at different locations.
To determine a possible position dependence (e.g. dependence of height
from the Z position), the measurement must be repeated at another position
(second height).
Enter all values in TNCopt and transfer to control.
CTC must then be enabled for all machining axes via MP2700 bit 0.
This function is described in detail in the Help function of TNCopt 6.0. Available
as of the end of 2011.
Checking the
compensation
To verify the compensation values, the measurement program must then be
run with active CTC. For test purposes you can activate and deactivate CTC
axis-specifically with MP2700 bit 0.
Blue curve = s_actl (W) without CTC, Green curve = s_actl (W) with CTC
To Next Page
Loading...
