July 2013 3.3 Handling the HDR hard disk 195
3.3 Handling the HDR hard disk
Shipping brace of
the hard disk
The HDR hard disks of the MC 6x4x are equipped with a shipping brace.
Before putting the iTNC 530 HSCI into service, the shipping brace of the hard
disk must be removed.
Should servicing become necessary (i.e. the HDR is being shipped on its own),
the hard disk must be secured with the shipping brace.
Do not transport the HDR with the MC 6x4x after you have installed the
HDR. If the entire machine is being transported, or the MC is being
transported inside the electrical cabinet, the shipping brace for the hard disk
is usually not required. However, if the possibility exists that the hard disk
could be subject to increased shock or vibration loads, then you must
remove the hard disk from the MC for transport, reinstall the shipping brace
in the HDR, and send the HDR separately in the original packaging.
When handling the HDR disk and the SIK, ensure electrostatic discharge
protection. Improper handling can result in damage to the components or
assemblies due to ESD!
To Next Page
Loading...
