July 2013 8.3 PLC soft keys 1385
Module 9208 Status information of the PLC soft keys
Call:
PS D <Resource handle>
Resource handle from Module 9203
PS B/W/D/K <Function>
0: Number of the current soft-key menu
PS B/W/D/K <Reserved>
0 transferred
CM 9208
PL D <Status information>
Error code:
8.3.2 Soft-key project file for HR 420, HR 5xx
Via the PLC, the iTNC can also manage freely-definable soft keys on the
HR 420 and HR 5xx handwheels. The corresponding entries are made in the
general soft-key resource file (*.spj) of the PLC project, in which the soft keys
for the vertical and horizontal soft-key rows of the iTNC screen are defined.
It is possible to switch from the basic menu of the HR, via the FCT (Function)
soft key, to a freely-definable submenu structure, each of which contains 5
soft keys, whose description and functions are specified in the soft-key
resource file.
This menu is displayed in the fourth row of the HR 420/HR 5xx . Four ASCII
characters are available for each soft key. However, if each soft key uses all
four characters, then there is no empty space between the soft-key
designations.
In addition, you can optionally have a menu title with 20 characters displayed
in the third row of the HR display for the main menu and each submenu.
The scope of function of the soft keys on the handwheel is limited somewhat
compared to the vertical and horizontal soft keys of the iTNC screen.
Marker Value Meaning
M4203 0 No error
1 Error code in W1022
W1022 2 Incorrect resource handle or incorrect function
20 Module was not called in a spawn or submit job
44 Error finding the status information
To Next Page
Loading...
