July 2013 3.8 Supply voltages in the HSCI system 233
X69: CC-supply
voltage and control
signals
Pin layout:
Combination of several CC 61xx controller units
Two drive-control motherboards are housed in one CC 6108 or CC 6110. Both
boards must be connected to the supply bus via the connectors X69A and
X69B. A short ribbon cable (ID 325 816-15) with three connectors for X69 is
therefore included with either of the two CCs. Two of the connectors are
connected to X69A and X69B of the CC, respectively. The third connector of
the cable serves to establish the connection to X69 of the power supply
module.
The ribbon cable with ID 325816-24 (100 mm) must be used for connecting
two CC 6106 controller units.
50-pin ribbon
connector
Assignment 50-pin ribbon
connector
Assignment
1a to 5b +5 V 16b GND
6a to 7b +12 V 17a RDY.PS
8a +5 V (low-voltage
separation)
17b GND
8b 0 V (low-voltage
separation)
18a ERR.ILEAK
9a +15 V 18b GND
9b –15 V 19a PF.PS.AC (only
UV 120, UV 140,
UV 150, UR 2xx)
10a UZAN 19b GND
10b 0 V 20a Do not assign
11a IZAN 20b GND
11b 0 V 21a Do not assign
12a RES.PS
21b GND
12b 0 V 22a Do not assign
13a PF.PS.ZK
22b GND
13b GND 23a Reserved (SDA)
14a ERR.UZ.GR
23b GND
14b GND 24a Reserved (SLC)
15a ERR.IZ.GR
24b GND
15b GND 25a RES.LE
16a ERR.TMP
25b GND
To Next Page
Loading...
