1376 HEIDENHAIN Technical Manual iTNC 530 HSCI
Additional
parameters for the
keywords
Entry in *.SPJ In connection with Meaning
VROOT SKMENU The menu for the vertical soft-key row is defined in
the header of the main menu.
HROOT SKMENU The menu for the horizontal soft-key row is defined in
the header of the main menu.
EMODE SKMENU The menu for the programming operating modes is
defined in the header of the main menu.
MMODE SKMENU The menu for the machine operating modes is
defined in the header of the main menu.
ENABLE:<Marker> NODE, BACK, END,
ACTION, PULSE,
CHECK, RADIO, STATE
Depending on the marker status, the soft key is either
locked (marker = 0) or enabled (marker = 1). A locked
marker is shown "inactive."
HIDE:<Marker> NODE, BACK, END,
ACTION, PULSE,
CHECK, RADIO, STATE
The parameter HIDE assigns a marker to a soft key. If
this marker receives the value 1, then that soft key is
hidden and exchanged for an "empty" soft key.
STATUS:<marker or
word>
NODE, BACK, END,
ACTION, PULSE,
CHECK, RADIO, STATE
An operand is assigned to the soft key (in addition to
W302/W304). If a marker is indicated and the soft key
is pressed, the marker is set. If a word is indicated, the
soft key number is entered (index number from the
*.sys file).
REPEATDELAY:
<Delay time in ms>
REPEATINTERVAL:
<Interval in ms>
ACTION, PULSE An "autorepeat function" can be realized for a soft key
by combining these two parameters. The function of
the soft key is performed after a delay (REPEATDELAY)
at a specified interval (REPEATINTERVAL).
STATES:<Marker> STATE The STATES parameter is used to tell a soft key how
many different states it can assume as the result of
repeated pressing. The assigned soft-key image file
must support the number of states (see the
BMXdesign software from HEIDENHAIN for more
information)
POPUPMENU:<Menu name> NODE, ACTION,
PULSE, CHECK, RADIO
The menu Menu name is shown in the other soft-key
row (either vertical or horizontal).
CLOSEPOPUPMENU NODE, BACK A menu opened with the POPUPMENU:<Menu name>
parameter is closed again.
LARGEWINDOW:
<Mask file for PLC
window>
NODE, ACTION,
PULSE, CHECK, RADIO
A large PLC window with the given mask file is
displayed across the entire screen.
To Next Page
Loading...
