July 2013 8.3 PLC soft keys 1377
SMALLWINDOW:
<Mask file for PLC
window>
NODE, ACTION,
PULSE, CHECK, RADIO
A large PLC window with the given mask file is
opened instead of the graphics/status window.
However, the user can extend it over the entire
screen.
CLOSEPLCWINDOW NODE, ACTION,
PULSE, CHECK, RADIO
A large PLC window opened with the LARGEWINDOW:
or SMALLWINDOW: parameter is closed again.
FirstInGroup ACTION, PULSE,
CHECK, RADIO
Defines a soft-key group. This keyword identifies the
first soft key of the respective soft-key group. A group
consists of at least two soft keys with the same
name, which can even be collected over multiple soft-
key rows (menus in the same level). The
functionalities listed above are set depending on the
soft-key keyword.
Evaluation via group code:
So that the operator entry can be evaluated via a
group code, the STATUS:<word> parameter must be
entered for the first soft-key in the group. No further
STATUS:<word> definitions may be entered within this
group.
ACTION, PULSE and CHECK soft keys:
The number of the soft key (within a soft-key group)
is transferred bit-coded in the dual system in the
given word, for example:
1st soft key (value = 1)
2nd soft key (value = 2)
3rd soft key (value = 4)
4th soft key (value = 8) ... e.g. 9th soft key (value =
256)
For groups with CHECK soft keys, more than one soft
key can be pressed at the same time. Here the
respective value of the group code is summed, and
the result is saved in the given word.
RADIO soft keys:
If this parameter is used in combination with a RADIO
soft-key group, the value of the group code is saved
as follows:
1st soft key (value = 0)
2nd soft key (value = 1)
3rd soft key (value = 2)
4th soft key (value = 3) …
Entry in *.SPJ In connection with Meaning
To Next Page
Loading...
