HEIDENHAIN iTNC 530 HSCI - Designation of the Software

July 2013 2.7 Software 139
2.7 Software
2.7.1 Designation of the software
The iTNC 530 HSCI features a separate software for the NC and the PLC. The
NC software is identified with an eight-digit number.
If you press the MOD key in any operating mode, you can display the
ID numbers of the NC software, the DSP software (CC) and the SKERN
software with active functional safety (FS). An installed service pack is shown
by SPx after the ID number of the NC software.
• Code number: Input field for code numbers
• NC-SW: NC software version and date
• FCL: Currently set Feature Content Level (FCL)
• PLC-SW: Number of the PLC program
• CC-SW: Software version of the CC, UEC and UMC controller units and
date
If the HEIDENHAIN integrated functional safety is active:
• MC-FS: SKERN software version of the MC main computer
• CC-FS: SKERN software version of the CC, UEC, UMC controller units
• SPLC-SW: Number of the SPLC program