July 2013 8.1 Display and operation 1167
smarT.NC
alternative
operating mode
Overview of the smarT.NC operating modes
smarT.NC: Programming operating mode
Program creation. This smarT.NC operating mode is comparable to
Programming and Editing of the Editor main operating mode.
smarT.NC: File Management operating mode
smarT.NC: Testing operating mode
This smarT.NC operating mode is comparable to Test Run of the Editor main
operating mode.
smarT.NC: Machining operating mode
Program run. This smarT.NC operating mode is comparable to Program Run,
Single Block and Program Run, Full Sequence of the Editor main operating
mode.
It is divided into the following sub-operating modes:
•„RUN SINGLE UNITS
Machine individual units without a special program context
•„RUN ALL UNITS
Completely machine the NC program
•„RUN ACTIVE UNIT
Machine an NC program unit by unit. Each unit must be started
manually.
Disabling operating
modes
PLC Module 9285 can be used to disable operating modes and other
functions.
To Next Page
Loading...
