HEIDENHAIN iTNC 530 HSCI - Special Case: Tool with the Predefined CMO Name Tool

1438 HEIDENHAIN Technical Manual iTNC 530 HSCI
In the description table below, this means that, for example, in line 3 the
objects defined in CMO_Portal will not be monitored for collision with the
objects defined in the name table ExcludeDef1 above.
Special case: Tool with the predefined CMO name "Tool"
In some cases it can be necessary to exclude the tool from monitoring for
collision with certain machine components (e.g. tool and tool carrier relative to
portal for B heads). For mechanical reasons a collision between these
components is impossible, but the tool is also permanently monitored for
collision with all objects. For example, if the distance between the tool and a
machine component with which it cannot collide becomes too small, this
could already lead to a reduced feed rate. In this case the tool can be excluded
according to the "Exclusion table" method described above by using the "Tool"
name to remove this possibility of collision from monitoring.
NR KEY AXIS COORD ON/OFF FILE DONTTEST
0 TOOLFILE
1 SUBFILE1
2 MachAxis B
3 CMO CMO_Portal ExcludeDef1
4 MachAxis X
5 MachAxis Y
6 CMO CMO_FloorSection
7 Trans X 470.0L92
8 Trans Y -282.405
9 Trans Z -900
10 CMO 1 CMO_Cabin
11 MachAxis Z
12 CMO CMO_LiftTable
13 MachAxis C
14 CMO CMO_TurnTable
[END]