162 HEIDENHAIN Technical Manual iTNC 530 HSCI
Deleting the packed
files of existing NC
software
While in the Programming and Editing operating mode, press the MOD key.
Enter the code number 95148 and confirm your entry with the ENT key.
While in the Machine-parameter programming mode, press the MOD key.
Press the UPDATE DATA soft key.
Press the SELECT soft key.
All NC software versions that exist in the control are shown in the following
options display.
Select the NC software to be deleted with the arrow keys and press the
DELETE soft key to delete all packed NC software files. The currently active
NC software is marked with an asterisk (*) in the Sel column. Confirm your
selection with the YES soft key. Press the NO soft key or the END soft key to
exit the list box without deleting an NC software.
If the packed files of an NC software, including the currently active
software, are deleted, the respective software cannot be activated via the
selection window any longer. The software concerned must then again be
transferred to the control.
The deletion of the packed files of the currently active NC software has no
other effects.
To Next Page
Loading...
