HEIDENHAIN iTNC 530 HSCI - Machining and Program Run

July 2013 4.4 List of machine parameters 557
4.4.14 Machining and program run
MP Function and input Software
version and
behavior
Page
MP7400 Look-ahead – Number of NC blocks for advance calculation
of the path
Input: 0: 256 [blocks] (default)
1: 512 [blocks]
2: 1024 [blocks]
PLC
RUN
1210
MP7410 Scaling cycle in two or three axes
Input: 0: Scaling cycle is effective in all three principal
axes
1: Scaling cycle is effective only in the working plane
PLC
RUN
CN123
1243
MP7411 Tool data in the touch probe block
Input:
Bit 0 –
0: Use the calibrated data of the touch probe
1: Use the current tool data from the last TOOL CALL
Bit 1 –
0: Only one set of touch probe calibration data
1: Use the tool table to manage more than one set of touch
probe calibration data; display the tool name and
tool number
PLC
RUN
CN123
1541
MP7412 Settings for cycles
Input:
Bit 0: Behavior of marker M4031 in Cycle 209
0 = Set M4031 after spindle orientation
1 = Set M4031 before the spindle orientation
PLC
RUN
CN123