1022 HEIDENHAIN Technical Manual iTNC 530 HSCI
Additional
temporary input
values for the
spindle
Enter the following additional temporary input values when you begin
commissioning the spindle:
Operating mode
switchover
During commissioning you can switch between operating mode 0 and
operating mode 1 with the CONNECT STAR DELTA soft key. With Module
9168 you can interrogate the current settings in the PLC. You can switch the
motor using PLC outputs and activate the corresponding machine parameters
with Module 9163:
Perform the adjustment for operating mode 0 and operating mode 1.
• If you do not use operating mode 1, set the corresponding machine
parameters to zero.
MP Temporary input
value
Meaning
MP3010.x 3 to 8 Output of speed, gear range
MP3020 991 Speed range
MP3411.x 1.999 Ramp gradient
MP3412.x 1 Multiplier for MP3411.x
MP3415.x 0 Overshoot behavior
MP3420 1 Positioning window
MP3440.x 1 k
v
factor
C-axis operation must be deselected for commissioning, meaning that no
identical PWM outputs may be entered in MP120.x and in MP121.x.
To Next Page
Loading...
