HEIDENHAIN iTNC 530 HSCI - Graphic Display; Projection in Three Planes; Rotation of the Coordinate System

July 2013 8.1 Display and operation 1275
8.1.25 Graphic display
In the graphics window you can view the following graphics:
 Test run graphics
 Parallel graphics
 Programming graphics
 Help graphic
For the test graphics and parallel graphics you can choose one of three display
modes:
 Projection in three planes
 Plan view
 3-D view
Projection in
three planes
The display in three planes can be shown in 1st-angle projection as preferred
in Germany or in the American-style 3rd-angle projection:
 Select the type of projection with MP7310, bit 0.
Rotation of the
coordinate system
You can rotate the coordinate system for graphic display by +90° if, for
example, the Y axis is defined as tool axis.
 Select the angle of rotation with MP7310, bit 1.
German preferrred U.S. preferred
Example
:
X
Z
No rotation
90° rotation
Z
X