July 2013 2.5 Overview of components 119
2.5.14 Touch probes
Touch probes are connected via the systemPL62xx or the UEC11x. The touch
probes generate a trigger signal that captures the current position value. For
more information about touch probes, please request the "Touch Probes"
brochure or CD-ROM from HEIDENHAIN.
The TS touch trigger probe has a stylus with which it probes workpieces. The
iTNC 530 provides standard routines for datum setting and workpiece
measurement and alignment. The touch probes are available with various
taper shanks. Assorted styli are available as accessories.
TS 220 touch probe
Triggering touch probe with signal transmission
over cable connection for machines with manual
tool change. For workpiece setup and
measurement during machining.
ID 293488-xx
ID 633613-xx
TS 220
Adapter cable for
connection to the
system PL or the UEC
To Next Page
Loading...
