July 2013 10.3 Connecting the iTNC to the Network 1873
Configuring an
interface
To log your control onto a standard network, proceed as follows:
Enter the code number NET123 in the PROGRAMMING AND EDITING
operating mode.
Press the DEFINE NET soft key
In the Computer name field, enter the name under which the control is to
identify itself in the network.
Select the Interfaces tab. Select the name of the interface (eth0),
connector X26 and press the Configuration button.
In the Settings of the interface under Profile, press the Load button.
Select the profile LAN-DHCP, and press OK to confirm your selection.
All other settings can be left at "Automatically procure", unless required
otherwise for your network.
To leave the Settings, press the OK button.
Then press the OK button again to confirm your changes in the network
settings.
Then restart the control with the Restart button.
To Next Page
Loading...
