994 HEIDENHAIN Technical Manual iTNC 530 HSCI
CC DIAG Available channels or signals of the CC-DIAG signal:
Num-
ber
Meaning
101 Status of emergency stop input
201 Masking the reference pulse via W1054/D1160
202 Activating the fine interpolation filter (nominal position value
filter is active)
203 Position controller is closed W1040/W1132
204 Position control is fed forward (MP1392, MP 1392)
205 Deactivation of monitoring functions via W1042/W1136
206 Position control in semifeedforward mode (MP1396)
207 Rapid switch-off of speed controller (activated in MP4130)
208 DC-link voltage monitoring can be activated via PLC module
9167. The current status can be read via this channel.
300 Ready signal of power module (green LED on the power module)
301 Error signal of power module (triggers an error message)
302 Output for controlling the brake at the power module (X 344)
400 UV ready signal of the inverter
401 DC-link voltage too high
402 DC-link current too high
403 Excessive temperature of UV
404 Leakage current detected by UV
405 AC fail signal is active
600 I2T early warning threshold of drive was exceeded
601 Axis enabled (PLC module 9157)
602 Axis is active (PLC module 9162)
603 Commutation angle of motor was measured using the reference
mark or EnDat
604 TNCopt function is currently being performed
To Next Page
Loading...
