HEIDENHAIN iTNC 530 HSCI - Cmo

1474 HEIDENHAIN Technical Manual iTNC 530 HSCI
CMO In a fixture, you can use additional CMOs. These collision monitored objects
must exist as files.
Input possibilities for CMOs:
Entry Input Description
Description
(DOC)
Any text Object designation used in the fixture
description.
File
(FILE)
Path and file
name
Path and file name of the CMO that is to be
used at this spot in the fixture kinematics.
Wizard CMO
(FCMO)
Active/Not active
via check box
When the Wizard CMO check box is
activated, a variable CMO is defined at this
position. The selection of the CMO actually
used occurs later in the FixtureWizard. The
FixtureWizard then offers the operator a
browser in which the path and file name of
the actual CMO can be entered (such as
for selection between step jaws and
square jaws).
Help graphic
(PICTURE)
Numerical value Path to the help-graphic file for a variable or
a variable subfixture.
Label text
(LABELID)
Any text Entry of a plain-language name or text ID.
Is displayed for the operator as an
additional aid when inserting the fixture.
You can use the PLCtext software tool to
create the texts as BMX texts. The texts
must be located in a Text subdirectory of
the respective fixture.