1716 HEIDENHAIN Technical Manual iTNC 530 HSCI
9.5.3 Data transfer NC program > NC (FN17: SYSWRITE)
You can use the FN17: SYSWRITE function particularly for OEM cycles if you
wish to overwrite certain NC data, e.g., an active basic rotation, from the NC
program. A group number, a system data number, and an index specify the
particular item of system data that you write: FN17: SYSWRITE IDxxxx NRxxxx
IDXxxxx = Qxxx or numerical value; comment. In the NC program you cannot
define function FN17 (soft keys: Q-parameter programming, special functions)
until you have entered the code number 555 343. After a control reset the
code number must be entered again if you want to program FN17. The iTNC
provides the following functions:
To Next Page
Loading...
