232 HEIDENHAIN Technical Manual iTNC 530 HSCI
3.8.5 Power supply of the CC 61xx
The CC 61xx controller unit is supplied with +5 V power by the power supply
units via supply bus X69 and connector X74, see page 233.
The control monitors the 5 V supply voltage. If it drops below 4.75 V, the error
message 5 V power supply too low appears. If it rises above 5.4 V, 5 V power
supply too high is indicated.
For information on the power supply units, refer to the "Inverter Systems
and Motors" Technical Manual.
Power consumption of CC 61xx:
CC 6106: 25 W
CC 6108: 35 W
CC 6110: 40 W
Device Load capacity
UVR 1xxD, UE 2xxD 20,00 A via X74
10.00 A via X69
Device Current consumption of the 5 V supply
CC 6106/6 control loops 3.80 A
Consisting of:
1 drive-control motherboard: 2.00 A
2 controller expansion PCBs: 0.90 A each
CC 6108/8 control loops 5.80 A
Consisting of:
2 drive-control motherboards: 2.00 A
2 controller expansion PCBs: 0.90 A each
CC 6110/10 control loops 6.70 A
Consisting of:
2 drive-control motherboards: 2.00 A
3 controller expansion PCBs: 0.90 A each
UxC drive control board 2.50 A
LS, LB 0.15 A
ERN, ROD, RON 0,20 A
Absolute rotary encoders 0.25 A (+0.085 A with line-drop
compensator)
a
a. For cable lengths > 10 m between the logic unit and the encoders
with EnDat interfaces, a line drop compensator is required
(efficiency = 75 %).
Absolute angle encoders 0.35 A (+0.085 A with line-drop
compensator)
a
LC 0.30 A (+0.085 A with line-drop
compensator)
a
To Next Page
Loading...
