July 2013 6.13 Integrated oscilloscope 1003
Circular test A circular interpolation test can be run in the oscilloscope.
Choose the CIRC operating mode in the oscilloscope.
Select the Contour dev. setting for the appropriate axes in the two
channels.
Start recording.
Start an NC program in which a circle is programmed. The circle center point
must be at the origin of both axes.
Stop recording.
Below the grid, the recording time relative to the trigger time point is
displayed.
Example of a circular interpolation test with the integrated oscilloscope:
Actual position:
X +30
Y +0
NC program:
0 BEGIN PGM Circular interpolation test MM
1 CC X+0 Y+0
2 CP IPA+360 DR+ F1000
3 M30
4 END PGM Circular interpolation test MM
To Next Page
Loading...
